Logo
{{ cart_count > 99 ? '99+' : cart_count }}

GA Gusset Angle

Model: GA1

{{ formattedPrice }} inc. GST {{ productData.list_price }}
{{ stock.company }} Qty: {{ stock.total_quantity }}
SKU: {{ sku }}
UOM Qty: {{ uomQty }}
{{ quantity }} exceeds {{ totalQuantity }} in stock – will be backordered 这里要加backorder时长 从产品数据内取.

To provide more consistent, straight corners, Simpson Strong-Tie offers a wide variety of angles in various sizes and thicknesses to handle light-duty jobs or projects where a structural connection is needed. The GA Gusset Angle is heavily swaged without any welding manufacturing process gives it extra strength for corners of 90° connection.

Please check the Corrosion Information to see if it is suitable for your application.

Material

Carbon Steel 1.3mm thick

Finish

Z275 Galvanised

Features & Benefits
  • Removes the guesswork for making perfectly square connections
  • Reinforces 90-degree connections
  • Stronger than angled nailing or screw fastening
  • Heavily swaged section provides extra strength
  • Stronger than angled nailing, wire dogs, or screw fastening
  • Help ensure joints are consistently straight and strong
  • Install with Simpson Strong-Tie 10d common nails or Strong-Drive SD screws
Installation
  • Use all specified fasteners
 
 
Model No. Table

Model No.

Fasteners
(No. – Length x Dia., mm)

Direction of Load

Design Capacity (kN)

Floor (k1 = 0.80)

Roof (k1 = 0.80)

Wind/ EQ (k1 = 1.0)

GA1

4 – 38 x 3.75

F1

1.38

1.38

1.38

F25

1.23

1.23

1.23
  1. Design Capacity is the lesser of (1) the Characteristic Capacity multiplied by the NZ Strength Reduction Factor (φ), and applicable the k modification factors following NZS 3603 and (2) the Serviceability Capacity which is the load at 3.2mm joint slip. Design Capacity is the minimum of test data and structural joint calculation.
  2. The Strength Reduction Factor (φ) is 0.80 for nails in lateral loading.
  3. Duration of Load Factor (k1) is as shown. Reduce Duration of Load Factor where applicable. Capacities may not be increased.
  4. Timber species for joint design is seasoned Radiata Pine, which is New Zealand Joint Group J5 per NZS 3603 Table 4.1.
  5. Connectors are required on both sides to achieve F2 loads in both directions.
 

Here is the brand introduction content...

Here are the parts content...